DiamaPro 5” Wet/Dry Honeycomb Pad, 200 grit

- Mid-low grit resin polishing pad for the second resin step — 200 grit follows the 50- and 100-grit honeycomb pads in the standard resin progression, removing the scratch pattern from the coarser resin steps and continuing the transition toward a polished surface. Part of DiamaPro Systems' resin polishing pad line, calibrated for cutting speed and tool life.

- Smaller 5" footprint for tight-area and detail polishing — the 5" diameter is sized for narrow edges, around columns and obstructions, on stair treads, in corners, and anywhere a 7" pad is too bulky to maneuver. The smaller pad is also easier to control on overhead work and detail polishing where operator fatigue from a heavier 7" pad becomes an issue. Choose 5" for precision work; choose 7" for production speed on open floors.

- Flexible honeycomb resin design for even pressure and dust evacuation — the hexagonal pattern molded into the pad's face creates large channels that evacuate dust during dry use and water during wet use, preventing the diamond surface from loading up. The honeycomb structure also flexes around contours and lippage, maintaining consistent contact pressure across the entire pad face — important for an even scratch pattern before progressing to finer grits.

- Wet/Dry dual-mode operation — usable in either condition: wet polishing reduces heat and extends pad life, dry polishing is more convenient on job sites without water access. Note: a 5" backing pad with hook-and-loop attachment is required to mount this pad to a 5" hand polisher (like the DiamaPro HGP-5). Do not run a 5" pad on a 7" backer — the size mismatch creates unsafe exposed hook-and-loop edges at high RPM.

- The honing-pad step for densifier application — per industry guidance, 200 grit is the recommended pad for "honing" the floor into shape before applying a densifier or hardener. The slightly opened surface profile allows even densifier penetration without leaving deep scratches that finer pads would struggle to remove. On a 5" pad, this is the matching step for the edge perimeter — both the main floor and the edges must hit 200 grit before densifier is applied to keep gloss development uniform across the whole slab.