Elite Series - 6 Grit Single Segment Orange Very Soft Concrete

- The most aggressive metal-bond grinding segment available — 6 grit goes below the standard 16-grit "coarsest" tier, designed for extreme stock removal where even a 16 grit isn't fast enough. Tears through the thickest coatings, heavy industrial mastic, multi-layer epoxy overlays, severe surface deformities, and badly damaged or contaminated slabs that need significant material removed before a normal grinding sequence can begin.

- Single-segment configuration for maximum cutting speed — a single segment per shoe creates less surface contact than a double, which means faster cutting speed and more aggressive material removal at the trade-off of shorter tool life. At 6 grit specifically, the goal is speed, not longevity — this is a tool you run hard, replace, and accept the cost as the price of getting through tough prep fast.

- Engineered for very soft concrete — very soft concrete (typically under 2,000 PSI, Mohs 2–3) is highly abrasive and rips through diamond segments fast. The orange color code designates the hardest metal bond in the Elite range, holding the diamonds in place longer to give usable tool life on a slab that would chew through softer bonds in a fraction of the time.

- Leaves a deep scratch pattern by design — at 6 grit, expect visible groove lines, exposed aggregate, and a rough surface. That's the point. After this pass, the progression must step up through 16, 25, 40, 80, and 100-grit metals before transitioning to resin pads. Skipping steps after a 6-grit cut will leave a scratch pattern that resin pads cannot remove.

- Specialist tool for severe prep, not a regular sequence starter — most jobs start at 16 or 25 grit. Reach for 6 grit only when the floor presents extreme conditions: deep coatings to strip, surface deformities to grind out, or large stock removal that warrants the extra step. Used correctly, it can cut hours off a heavy prep job; used unnecessarily, it just adds a step and prolongs the grind.